Maximising thermal protection whilst minimising buoyancy, the
HALO 3D has body mapped insulation, strategically placed to enhance
protection when in horizontal trim. Designed for use underneath membrane
and trilaminate suits, the HALO 3D is the perfect complement to our
current range of drysuit thermal protection. In a layering combination
with xerotherm, HALO 3D is suitable for the harshest diving conditions
on the planet.
One Piece Design
The one piece design is simple and functional; lower profile
around the hips and midriff, allowing high maneuverability with panels
of additional thermal protection layers located where they are needed
most, enhancing the thermal protection in critical zones without
excessive bulkiness. It can be worn as part of a layer system with
drybase, xerotherm and in extreme cases, even Arctic.
SpaceTek Compression Resistant Panels
SPACETEK material blends perfectly with the dual layer
construction to provide a constant, compression resistant layer of air
on the torso front, thighs and shoulders. The benefit of this additional
protection becomes clear, as soon as you enter the water as you feel
cocooned by 8mm thick enhanced thermal protection layers.
High Density Fleece
Three layers of heavyweight, high density material enhance
protection of critical areas. The back, kidney region, buttocks and
hamstring region are protected. Combined with the insulation offered by
the SPACETEK material, you will feel warmer and better protected.
Right Arm Pocket
There is a useful pocket in the right arm is ideal for small valuables.
P-valve holes are located at the inner thigh on both legs so
the user can select the preferred leg for routing the catheter, the
holes are not fully open as only a small number of users will need to
use them. If a p-valve is required you will need to carefully cut using
sharp scissors to open the hole wide enough for the catheter tube to fit
through. Be careful not to cut into or beyond the end of the button
hole stitching as this will allow the fabric to fray.